Thursday, November 21, 2024

All the info in replacing the bulb in your ashtray's orange ring

Replacing the bulb in your ashtray's orange ring


  • UPDATE! The lights from the light switch of my car were not staying on after switching on the headlights, they went out every time after ~5 seconds, either was the light of my hazard button. But now that I have replaced the light bulb of the ashtray, the lights now stay on! So it is a very easy fix!!!!

  • To replace the light bulb we have to take apart a lot of things and it is very upsetting that otherwise we cannot see if the light bulb is defective or not. For this we are going to start by opening the ashtray and remove the 2 screw covers. This can be done with a small flat head screwdriver. It has to be done gently so that we don't damage the plastics, either from the covers, or from the ashtray. 











  • Next, we unscrew the 2 screws (that in the pictures I have already taken out) and pull out the ashtray unit with force. In the back of the unit there are some clips that hold it in place so we have to unhook the unit. Repetitive short strong pulls will take it out. 
  • With the ashtray out, we have to remove the light bulb case unit. First remove the securing clip that is on the light bulb unit. With the small flat head screwdriver gently pry of the clip.





                    

  • Now we can remove the light bulb case unit. Again using the small flat head screwdriver, pry out the unit. Gently, slight force is enough, be careful not to break anything.










With the light bulb case unit out we have to take out the light. Finally! We use the small head screw driver to open the casing and to finally remove the bulb itself. be careful because this requires some force and since is a small unit, very small unit the screw driver can slip and hurt our fingers! Again, be careful and work with love and dedication! You will succeed!













  •  With this we have to replace the bulb and then in reverse order we putt everything back! Simple! Have fun! Succes



The type of bulb used is:


Type  T5 glass base matt
Voltage: 12 V
Power: 1.2W
Length max. 20 mm
diameter max. 5 mm

  




No comments:

Post a Comment

Lights from the light switch problem

If the lights from the lights switch, or the light from the hazard button  don't stay on after turning on the lights  it may be becaus...